Injection Machines Troubleshooting

  • Home
  • Injection Machines Troubleshooting

Dear technician, in this section, you can discuss about your injection problems with us and wait for your solutions from Artak Machine technical unit. In this section, you can reach to a wide range of useful and valuable information in the field of troubleshooting and repairing injection molding   machines.Here are some on the main problems the machines have been facing with and the solutions:

Reasons that lead to this problem include low gearbox pressure and speed, over-tight or jammed nut (the back nut of the tie and the flywheel gear.
The pressure and speed of the first step of opening can be high or the stop are not set correctly.
Not being centered for injection unit and the mold sprue bush or low system pressure can cause this problem. It must also be ensured that the nozzle head is sealed with a mold inlet. In some cases, a defect in the cylinder or its valve can cause such a problem.
Excessive temperature rise of the element can be due to the connection of the contactor, SSR or PLC relay.
To ensure that the mold is sound and the clamp of the machine is calibrated, the clamp pressure and the injection pressure must be compatible.
guest
4 دیدگاه
پیمان قلیچ
پیمان قلیچ
3

سلام من یک دستگاه 270 تن چینی دارم مدل 2009 و سبد تولید میکنم چند وقت هست که بارگیری دستگاه به مشکل خورده یعنی وقتی که مواد در سیلندر هم نیست ماردون به عقب برمیگرده و حین کار هم مدام خط کش تغیر وضعیت میده لطفا راهنمایی کنید ممنون

artakmachine
artakmachine
3

با سلام و تشکر از پیام شما
لطفا در خصوص عقب رفتن ماردون و تغییر وضعیت خط کش توضیحات بیشتری بیان فرمایید.
در حالت کلی امکان خرابی خط کش وجود دارد.
منتظر توضیحات بیشتر از سمت شما خواهیم بود.

پیروز باشید

4
0
()
x
X